Congratulations on receiving your new S2/S3! Use this guide to learn about pairing S2/S3 with your preferred device, charging the battery, and restoring the speaker to its factory settings.
What's included in the box
- S2/S3 speaker
- Type-C USB-cable
- Warnings Folder
- Owners manual
Before getting started
The speaker will likely have some existing battery charge, however it is recommended to fully charge S2/S3 before using it for the first time.
Turning S2/S3 on or off
Press (hold) the play button for two seconds to turn on/off your S2/S3.
Pairing with a device
Press (hold) the play button for two seconds to turn on your S2/S3. The speaker is now on and in pairing mode.
Open the Bluetooth settings on your device and wait for S2/S3 and the device to locate each other, then select Sudio S2/S3 when it appears in the list.
In order to disconnect S2/S3 and return it to pairing mode, you can press (hold) the broadcast button for 2 seconds, the LED light will blink white two times.
Charging the battery
S2/S3 has one built-in battery inside the speaker.
S2/S3 is charged with a Type-C USB-cable. It is recommended to use the Sudio Type-C USB-cable that's included in the package, but the charging case may be compatible with third-party Type-C USB-cables as well.
There is one LED-light on the top of the S2/S3 that indicates the speaker's battery remaining level.
Restoring S2/S3 to factory settings
If S2/S3 is behaving unexpectedly or you simply wish to restore it to its original settings, then you can reset it. You may then proceed with pairing S2/S3 again.
Comments
Article is closed for comments.