Congratulations on receiving your new pair of A2! Use this guide to learn about pairing A2 with your preferred device, charging the batteries, and restoring the earphones to their factory settings.
What's included in the box
- A2 wireless earphones and charging case
- Interchangeable ear tips in five different sizes: XS, S, M, L & XL
- Type-C USB-cable
- Microfiber cloth
- Owners manual
Before getting started
⚠️ Sudio A2 is delivered with a red protective film covering the charging connectors between the earbuds and charging case. The film needs to be removed in order for the earbuds to power on.
The earbuds will likely have some existing battery charge, however it is recommended to fully charge A2 before using it for the first time.
Turning A2 on or off
A2 powers up as soon as the earbuds are removed from the charging case.
Similarly, A2 is turned off when placing the earbuds back into the case.
You can also use the touch controls to power the earbuds off. Do this by holding the touch control for 6 seconds on either earbud.
Pairing with a device
A2 enters pairing mode when the earbuds are removed from the charging case. Open the Bluetooth settings on your device and wait for A2 and the device to locate each other, then select Sudio A2 when it appears in the list. You will hear 🔈 Connected, confirming that the devices are paired with each other!
Charging the batteries
There are three batteries in total on A2; one in the charging case and one in each earbud.
The A2 earbuds charge their batteries automatically when placed inside the charging case, this is indicated by the LED lights on the charging case. Make sure to first remove the protective film which is covering the charging connectors.
The A2 case is charged with a Type-C USB-cable and can also be charged wirelessly. When the case is charging, you will see several lights on the front of the charging case. It is recommended to use the Sudio Type-C USB-cable that's included in the package, but the charging case may be compatible with third-party Type-C USB-cables as well.
Restoring A2 to factory settings
If A2 is behaving unexpectedly or you simply wish to restore it to its original settings, reset it by taking the earbuds out of the case and touching (holding) the touch points on both earbuds for 6-8 seconds until you hear Power Off. Then release and touch (hold) the touch points on both earbuds for 8 seconds again until you hear 3 clicks. Leave the earbuds close to one another until they resynchronize with each other.
You may then proceed with pairing A2 again.
Comments
Article is closed for comments.