Congratulations on receiving your new pair of T2! Use this guide to learn about pairing T2 with your preferred device, charging the batteries, and restoring the earphones to their factory settings.
What's included in the box
- T2 wireless earphones and charging case
- Interchangeable ear tips in four different sizes: XS, S, M & L
- Type-C USB-cable
- Microfiber cloth
- Owners manual
Before getting started
⚠️ Sudio T2 is delivered with a protective film covering the charging connectors between the earbuds and charging case. The film needs to be removed in order for the earbuds to power on.
The earbuds will likely have some existing battery charge, however it is recommended to fully charge T2 before using it for the first time.
Turning T2 on or off
T2 powers up as soon as the lid on the charging case is opened, as indicated by the LED lights on the earbuds and the audio feedback 🔈 On.
Similarly, T2 is turned off when placing the earbuds back into the case.
You can also use the touch controls to power the earbuds on or off. Do this by holding the touch control for 5 seconds on either earbud.
Pairing with a device
T2 enters pairing mode when opening the lid on the charging case. Open the Bluetooth settings on your device and wait for T2 and the device to locate each other, then select Sudio T2 when it appears in the list. You will hear 🔈 Connected, confirming that the devices are paired with each other!
Charging the batteries
There are three batteries in total on T2; one in the charging case and one in each earbud.
The T2 earbuds charge their batteries automatically when placed inside the charging case, this is indicated by the LED lights on the earbuds. Make sure to first remove the protective film which is covering the charging connectors.
The T2 case is charged with a Type-C USB-cable. When the case is charging, you will see a light below the charging port (where the cable is inserted). It is recommended to use the Sudio Type-C USB-cable that's included in the package, but the charging case may be compatible with third-party Type-C USB-cables as well.
Restoring T2 to factory settings
If T2 is behaving unexpectedly or you simply wish to restore it to its original settings, reset it by placing the earbuds inside the case and, with the lid open, press the button on the bottom side of the case for 5 seconds. The reset is complete when the LED light on the case flashes white twice.
You may then proceed with pairing T2 again.
Comments
Article is closed for comments.