T2 - User guide - Factory reset

t2-factory-reset.png

If T2 starts behaving unexpectedly, or if you wish to remove the connection between T2 and the connected device, you can perform a factory reset to restore your Sudio T2 to its original settings. This will reset the connection between your paired devices, as well as the connection between the two earbuds.

  1. Place the earbuds back into the charging case and keep the lid open.
  2. Press and hold the reset button on the bottom side of the case for 5 seconds.
  3. The factory reset is complete when the LED light on the back of the case flashes white twice.
  4. Close the lid and allow 1-2 minutes before using the earphones again.

When you hear 🔈 Ready to pair, find your Sudio product in the Bluetooth list of your device, proceed to pair them with your Bluetooth device.

Was this article helpful?
6 out of 26 found this helpful

Comments

0 comments

Article is closed for comments.