Congratulations on receiving your new F2! Use this guide to learn about pairing F2 with your preferred device, charging the battery, and restoring the speaker to its factory settings.
What's included in the box
- F2 speaker
- Type-C USB-cable
- Warnings Folder
- Owners manual
Before getting started
The speaker will likely have some existing battery charge, however it is recommended to fully charge F2 before using it for the first time.
Turning F2 on or off
Press (hold) the power button for two seconds to turn on/off your F2.
Pairing with a device
F2 will automatically be in pairing mode after having been turned on by pressing the power button for two seconds. The light on the far left will start flashing white/orange.
Open the Bluetooth settings on your device and wait for F2 and the device to locate each other, then select Sudio F2 when it appears in the list.
In order to disconnect F2 and return it to pairing mode, you can press (hold) the play button for 2 seconds.
Charging the battery
F2 has one built-in battery inside the speaker.
F2 is charged with a Type-C USB-cable. It is recommended to use the Sudio Type-C USB-cable that's included in the package, but the charging case may be compatible with third-party Type-C USB-cables as well.
There is one LED-light on the left side of the buttons that indicate the speaker's battery remaining level.
Restoring F2 to factory settings
If F2 is behaving unexpectedly or you simply wish to restore it to its original settings, then you can reset it. You may then proceed with pairing F2 again.
Comments
Article is closed for comments.