Congratulations on receiving your new B3! Use this guide to learn about pairing B3 with your preferred device, charging the battery, and restoring the headset to its factory settings.
What's included in the box
- B3 headset
- USB-C charger
- Owners manual
- Warnings Manual
Before getting started
⚠️ Sudio AB is delivered with a protective film covering the charging connectors between the earbuds and charging case. The film needs to be removed in order for the earbuds to charge/turn on.
The earbuds will likely have some existing battery charge, however it is recommended to fully charge B3 before using it for the first time.
Turning B3 on or off
B3 powers up as soon as the earbuds are removed from the charging case, as indicated by the LED lights on the earbuds and the audio feedback 🔈 Power On.
Similarly, B3 is turned off when placing the earbuds back into the case.
You can also use the touch controls to power the earbuds on or off. Do this by holding the touch control for 7 seconds on either earbud.
Pairing with a device
Hold the plus (+) button control for 2 seconds until you hear the audio feedback 🔈 On. Open the Bluetooth settings on your device and wait for B3 and the device to locate each other, then select Sudio B3 when it appears in the list. You will hear 🔈 Connected, confirming that the devices are paired with each other!
Charging the battery
There are three batteries in total on B3; one in the charging case and one in each earbud.
The B3 earbuds charge their batteries automatically when placed inside the charging case. Make sure to first remove the protective film which is covering the charging connectors.
The B3 case is charged with a Type-C USB-cable. When the case is charging, you will see a light on the front of the charging case. It is recommended to use the Sudio Type-C USB-cable that's included in the package, but the charging case may be compatible with third-party Type-C USB-cables as well.
Restoring B3 to its factory settings
If B3 starts behaving unexpectedly, or if you wish to remove the connection between B3 and the connected device, you can perform a factory reset to restore your Sudio A3 to its original settings. This will reset the connection between your paired devices, as well as the connection between the two earbuds.
1. Take the earbuds out of the charging case.
2. Wait until the earbuds have gone through the voice feedback saying: 🔈 Ready to pair, find your Sudio product in the Bluetooth list of your device. Then proceed with pressing and holding both touch points on the earbuds for 6-8 seconds until you hear Power Off.
3. Release the touch button, and once again hold both touch points of the earbuds for 6-8 seconds until you hear 3 clicking sounds.
4. Leave the earbuds out of the case and close to one another for 20 seconds so they can resynchronize.
5. Place the earbuds back in the case and close the lid and allow 1 minute before using the earphones again.
Comments
Article is closed for comments.