Congratulations on receiving your new pair of D1! Use this guide to learn about pairing D1 with your preferred device, charging the batteries, and restoring the earphones to their factory settings.
What's included in the box
- D1 wireless earphones and charging case
- Type-C USB-cable
- Interchangeable ear tips in four different sizes: XS, S, M & L
- Owners manual
- Warnings Manual
Before getting started
⚠️ Sudio D1 is delivered with a protective film covering the charging connectors between the earbuds and charging case. The film needs to be removed in order for the earbuds to charge/turn on.
The earbuds will likely have some existing battery charge, however it is recommended to fully charge D1 before using it for the first time.
Turning D1 on or off
D1 powers up as soon as the earbuds are removed from the charging case, as indicated by the LED lights on the earbuds and the audio feedback 🔈 Power On.
Similarly, D1 is turned off when placing the earbuds back into the case.
You can also use the touch controls to power the earbuds on or off. Do this by holding the touch control for 7 seconds on either earbud.
Pairing with a device
D1 enters pairing mode when the earbuds are removed from the charging case. Open the Bluetooth settings on your device and wait for D1 and the device to locate each other, then select Sudio D1 when it appears in the list. You will hear 🔈 Pairing Successful, confirming that the devices are paired with each other!
Charging the batteries
There are three batteries in total on D1; one in the charging case and one in each earbud.
The D1 earbuds charge their batteries automatically when placed inside the charging case, this is indicated by the LED lights on the earbuds. Make sure to first remove the protective film which is covering the charging connectors.
The D1 case is charged with a Type-C USB-cable. When the case is charging, you will see a light on the front of the charging case. It is recommended to use the Sudio Type-C USB-cable that's included in the package, but the charging case may be compatible with third-party Type-C USB-cables as well.
Restoring D1 to factory settings
If D1 is behaving unexpectedly or you simply wish to restore it to its original settings, reset it by taking the earbuds out of the case and touching (holding) the touch points on both earbuds for 6-8 seconds until you hear Power Off. Then release and touch (hold) the touch points on both earbuds for 8 seconds again until you hear 3 clicks. Leave the earbuds close to one another until they resynchronize with each other.
You may then proceed with pairing D1 again.
Comments
Article is closed for comments.