E3 - User guide - Factory reset

If E3 starts behaving unexpectedly, or if you wish to remove the connection between E3 and the connected device, you can perform a factory reset to restore your Sudio E3 to its original settings. This will reset the connection between your paired devices, as well as the connection between the two earbuds.

  1. Place the earbuds back into the charging case and keep the lid open.
  2. Press and hold the reset button on the back of the case for 5 seconds.
  3. The factory reset is complete when the LED light on the front of the case flashes white twice.
  4. Close the lid and allow 1-2 minutes before using the earphones again.

When you hear 🔈 Ready to pair, find your Sudio product in the Bluetooth list of your device, proceed to pair them with your Bluetooth device.

Was this article helpful?
0 out of 1 found this helpful



Article is closed for comments.