Congratulations on receiving your new pair of A1! Use this guide to learn about pairing A1 with your preferred device, charging the batteries, and restoring the earphones to their factory settings.
What's included in the box
- A1 wireless earphones and charging case
- Type-C USB-cable
- Owners manual
- Warnings Manual
Before getting started
⚠️ Sudio A1 is delivered with a protective film covering the charging connectors between the earbuds and charging case. The film needs to be removed in order for the earbuds to charge/turn on.
The earbuds will likely have some existing battery charge, however it is recommended to fully charge A1 before using it for the first time.
Turning A1 on or off
A1 powers up as soon as the earbuds are removed from the charging case, as indicated by the LED lights on the earbuds and the audio feedback 🔈 Power On.
Similarly, A1 is turned off when placing the earbuds back into the case.
You can also use the touch controls to power the earbuds on or off. Do this by holding the touch control for 7 seconds on either earbud.
Pairing with a device
A1 enters pairing mode when the earbuds are removed from the charging case. Open the Bluetooth settings on your device and wait for A1 and the device to locate each other, then select Sudio A1 when it appears in the list. You will hear 🔈 Pairing Successful, confirming that the devices are paired with each other!
Charging the batteries
There are three batteries in total on A1; one in the charging case and one in each earbud.
The A1 earbuds charge their batteries automatically when placed inside the charging case, this is indicated by the LED lights on the earbuds. Make sure to first remove the protective film which is covering the charging connectors.
The A1 case is charged with a Type-C USB-cable. When the case is charging, you will see a light on the front of the charging case. It is recommended to use the Sudio Type-C USB-cable that's included in the package, but the charging case may be compatible with third-party Type-C USB-cables as well.
Restoring A1 to factory settings
If A1 is behaving unexpectedly or you simply wish to restore it to its original settings, reset it by placing the earbuds inside the case and press the button on the bottom of the case for 5 seconds. The reset is complete when the LEDs lights on the front of the case flashes white twice.
You may then proceed with pairing A1 again.
Comments
Article is closed for comments.